Looking for a resistance baseline for injectors

[DrEntropy]

Is there a baseline resistance for these things?

One of six is obviously dead, zero resistance. The other two on the same head are well down below 10Ω. The opposite side, all consistent at 10+Ω. The higher resistance ones are obvious replacements, as well. The three rear (lower resistance) ones look to be originals.

Would the dead one on the low side drag down the other two from actuating?

 

[melsg5]

This link has resistance for most cars including the Sunbird

http://www.aatecusa.com/obdIIpro/me.../gm etc/Injector Resistance Table 2_21_01.PDF

 

[DrEntropy]

That gives me precisely the info needed. Sir! Right bank will get three new "spritzermachens"!!

Thank you again!

 

[TrojanMan]

These guys used to have a top ten worst injectors list.
Those factory spritzermachens were on it.
http://www.lindertech.com/reconinj.htm

______________________________

 

[DrEntropy]

That's certainly enlightening.

Pulled the "back" three and replaced 'em. Stumble and acceleration issue solved.

Thank you all.

Now to start another thread.