Burdedw
New member
Hi All,
I'm new to this forum since I just bought an 86 Fiero a couple of weeks ago. I like the car and I'm working on a number of items to put it back in good shape. It had a lot of deferred maintenance that I'm catching up on. Right now I'm working on getting the cruise control working and have installed a new switch (turn signal stalk) My issue is that the replacement that was guaranteed to fit has a 4 wire blade connector and my original one has a 6 pin rectangular connector with 4 of the pins being used by the cruise control. I would like to splice the old connector to the new switch's wires, but the colors are not the same. The old one had red, orange, brown and brown with a yellow stripe, and the new one has green, yellow, blue and red. Has anyone done this before and could help me out? I'd be grateful.
Thanks, David
I'm new to this forum since I just bought an 86 Fiero a couple of weeks ago. I like the car and I'm working on a number of items to put it back in good shape. It had a lot of deferred maintenance that I'm catching up on. Right now I'm working on getting the cruise control working and have installed a new switch (turn signal stalk) My issue is that the replacement that was guaranteed to fit has a 4 wire blade connector and my original one has a 6 pin rectangular connector with 4 of the pins being used by the cruise control. I would like to splice the old connector to the new switch's wires, but the colors are not the same. The old one had red, orange, brown and brown with a yellow stripe, and the new one has green, yellow, blue and red. Has anyone done this before and could help me out? I'd be grateful.
Thanks, David
