Overheat warning

So I guess you are happy with the progress you are making.
 
0118 code seems like a wiring issue. All the videos I saw said the open circuit should result in a -40f sensor reading. And I was getting a 140f reading. So the sensor was reading the low coolant temp properly. It was working as intended. Yes I am happy ac works and temp gauge works. But I think it is not fixed.
 
Drove about 1 hr yesterday. Went to a few stores. Used ac a bit. Turned ac off. Temp gauge still works. Speedo seems correct. Might change wheel bearing as constant stabilitrak warning is annoying.
 
Thanks for the update
______________________________
 
3days driving now. No overheat issues. Temp gauge still works. Just poking the car gods by reporting all is well.
 
What is the remaining code?
 
Picked up a used gauge cluster. Tach works now. And both speedo/tach do full gauge sweep on start. My old cluster never did that. Even the temp/gas needles do a little sweep.
______________________________
 
Thanks for the update
 
You must log in or register to reply here.

Share this page

Back
Top